Reparatii barci gonflabile gen zodiac

Discutii legate de pescuit.
sever
Posts: 272
Joined: 04 Oct 2010 21:43
Contact:

Reparatii barci gonflabile gen zodiac

Postby sever » 21 Oct 2013 14:02

Pt. cei interesati:

Choosing the right glue or adhesive to repair your inflatable dinghy or boat tender can be confusing. There are many variations of adhesive on the market and some could leave you unstuck at a dangerous moment. When you’re on the water, you’re also as risk, and the wrong type of adhesive is a risk you don’t want to take.

Adhesive – Glue Types

Inflatable Boat Fabric (Hypalon or PVC Adhesive?)
In the case of inflatable boats and dinghies, the fabric construction is the first important fact to determine, is it Hypalon fabric or PVC fabric. Our ‘PVC or Hypalon Fabric‘ guide will help you determine what your Honwave Dinghy, Plastimo, Scorpion or Quicksilver Inflatable dingy is made of.

Single Part Glue or Two Part Adhesive?
Single part adhesive, basically a simply applied glue direct from a tube. This is OK for quick repairs and temporary emergency dinghy repairs, but not recommended for a lasting robust repair to your inflatable boat.

Single part adhesive can also be used as a primer for preparing Rubber or PVC Fittings prior to securing to the opposite material of PVC or Rubber inflatable tubes with a permanent 2 part adhesive.

Two Part Adhesives offer greater strength when fixing rubbing strake, handles and inflatable boat accessories to the tubes. Also fixing holes and damaged seams requires the durability of a two part adhesive. Ploymarine adhesives for both Hypalon and PVC have a strong heritage being a product of choice for liferaft service stations and major manufacturers.

sever
Posts: 272
Joined: 04 Oct 2010 21:43
Contact:

Re: Reparatii barci gonflabile gen zodiac

Postby sever » 21 Oct 2013 14:16

Si mai departe

http://zodiaciboats.blogspot.ro/

Patching an Inflatable Boat is a fairly simple procedure for small pin-hole leaks on the air chambers.



The main steps are as follows.

1. Roughen all surfaces to be patched with No. 100 Sandpaper.

2. Wash sanded surfaces with Acetone.
3. Use a patch of approximately 2 1/2" to 3" in diameter.

4. Use masking tape on the repair area to outline the perimeter of the patch to make a neat repair.

5. Apply adhesive to the patch and area to be repaired. Three applications are required. Details are provided below.

6. Apply the patch in such a manner as to avoid trapping any air bubbles under the patch.

7. Compress the patch to the repair area with a roller or compression tool.

8. Allow the patch to cure for at least 72 hours before putting the boat into the water.


Details
Exercise caution when using acetone as it tends to remove a layer of the skin of the Inflatable. Also it is recommended that you use proper protective gear such as gloves and a well ventilated work area to do the repair.

The repair should be done in suitable environmental conditions. The ambient air temperature should be 18 deg. C to 25 deg. C. Humidy should not exceed 78% otherwise the drying glue will accumulate condesation and the patch will not adhere properly.

Patch & Glue Types
Zodiac supplies the correct patches and glue in their repair kit that comes with the boat. If you have used up your patches or glue or buy a used boat without the repair kit, you will have to go to a Zodiac Inflatable Boat repair shop to buy the appropriate patch material or glue. Inflatable Boats are built in two main types of material. PVC or Hypalon. It is recommemded that you purchase the same patching material as the boat. The same applies for the glue. Zodiac has two different types of glue that they recommend for the repair of Inflatables. For the PVC boats they recommend Pastomere All Purpose Adhesive. For Hypalon, Zodiac recommends Neoprene Adhesive. In a pinch, you can use the Pastomere Glue on Hypalon material with extremely careful preparation. Keep in mind that Hypalon is a more finicky material and requires careful preparation at any time to make a good patch job.

Glue is available in small tubes and in approximately 800 cc cans for larger jobs. The can comes with an Accelerator which is added to properly cure the glue. Read the instructions on the can for proper mixing and application instructions.

Patching Techniques
To make a professional looking job, trace the outline of the patch onto the area to be repaired with a pencil and use masking tape to mask off the patch area to prevent the glue from over running onto the rest of the Tube.
Use a Camel-Hair brush or similar type. Using a brush with plastic type bristles will not work as the bristles will dissolve in the glue. Next apply three thin coats of glue onto the repair area and the patch. Allow each coat to dry for approximately 8 to 12 minutes before applying the next coat. Once the final cost is dry, the patch is ready to be applied.
Apply the patch carefully to avoid trapping any air bubbles under the patch. Use a roller or a compression tool to properly compress the patch onto the Tube.
Remove the masking tape and finish the job with a wash of the excess glue around the patch area with Acetone.

User avatar
busu4x4
Posts: 948
Joined: 23 Sep 2010 14:15
Location: Bucuresti, Tineretului
Contact:

Re: Reparatii barci gonflabile gen zodiac

Postby busu4x4 » 21 Oct 2013 22:44

Intrebare: Ai exersat ceva pe barca lui Suzuker? :mrgreen: :lol: :mrgreen:
Live Free or Die Hard !!!!

sever
Posts: 272
Joined: 04 Oct 2010 21:43
Contact:

Re: Reparatii barci gonflabile gen zodiac

Postby sever » 22 Oct 2013 11:47

Nu am exersat nimic inca, din acest motiv cautam ceva indicii, pt ca din batrani s-a auzit vorba prenadez si cauciuc de camera sau ceva de genul iar eu am fost oleaca suspicios.

Asta nu inseamna ca nu merge si cu prenadez si camera sau altceva de genul asta.

User avatar
Razvan4x4
Posts: 2026
Joined: 17 Sep 2010 11:20
Location: Bucureşti
Contact:

Re: Reparatii barci gonflabile gen zodiac

Postby Razvan4x4 » 22 Oct 2013 11:57

Mai bine sa nu fie nevoie...
Casa Iacob nu e acasa

User avatar
RZV
Macaragiu
Posts: 1238
Joined: 18 Sep 2010 20:34
Contact:

Re: Reparatii barci gonflabile gen zodiac

Postby RZV » 22 Oct 2013 16:07

Hint:
Daca ai barca din Hypalon si ai nevoie de reparatii de orice fel-furcheti pt visle,prinderi pentru scaune,mutat visle mai comod in fata-spate,oglinda-mai mare, mai mica, mai groasa,alta forma,prinderea de balon...-orice,atit Matache cit si Lipoveanu se cunosc cu proprietarul fabricii din Bucuresti de "bijuterii" gonflabile. Orice-aproape- este posibil in citeva zile sau chiar mai repede daca nu sunt comenzi de onorat la momentul cerintei.

Sa incerci sa repari singur asa ceva este un pic mai delicat si de preferat sa ocolesti subiectul daca nu intelegi perfect fenomenul :lol:
Zic si eu ,stiind ca lucrul facut cu mina ta este lucru manual.....sau la*a, dupa caz....
Mai bine macaragiu, decit bulangiu ........

AdrianZUZ
Posts: 303
Joined: 05 Oct 2010 09:37
Contact:

Re: Reparatii barci gonflabile gen zodiac

Postby AdrianZUZ » 23 Oct 2013 07:39

Daca e din hypalon, ma suni pe mine si iti lipesc ce vrei tu cu garantie pe viata ... daca e PVC nu ma bag ca nu am testat si nici nu am "pernandez"

@RZV - nu e bre nimic "delicat", doar ca este scris in engleza! :P

PS - Pentru hypalon nu se foloseste acetona. Este bine sa ai la indemana toluen, atat ptr curatare cat si ptr reactivarea lipiciului daca gresesti ceva (pozitie, timing ...)
:mrgreen: ATENTIE LA BICICLIST :mrgreen: !

User avatar
RZV
Macaragiu
Posts: 1238
Joined: 18 Sep 2010 20:34
Contact:

Re: Reparatii barci gonflabile gen zodiac

Postby RZV » 23 Oct 2013 08:50

Razvan wrote:Sa incerci sa repari singur asa ceva este un pic mai delicat si de preferat sa ocolesti subiectul daca nu intelegi perfect fenomenul :lol:
....



Daca tu stii sa lipesti esti ok dar eu nu ma pricep ?!?HA?!?
Si daca vrea cineva o oglinda noua ca a lui este mincata/rupta/scurta? Sau sa mute cu 15cm mai in fata suportii pt visle?

Iar o dam in cine stie mai bine ......iar vine cineva si spune ca ne chitrosim,iar, iar....
Pt un petic ca nu sunt atent si am intepat-o esti probabil mai comod si sigur mai rapid dar pentru alte operatiuni ca cele enumerate mai sus,probabil ca nu reusesti sa dai acelasi randament cu cei ce asta fac zilnic. Si aici am dreptate,oricit mi-as dori sa te invadeze acasa pt 3-5 ore cei doi jnapani cu barci de aici. :lol:
Mai bine macaragiu, decit bulangiu ........

User avatar
busu4x4
Posts: 948
Joined: 23 Sep 2010 14:15
Location: Bucuresti, Tineretului
Contact:

Re: Reparatii barci gonflabile gen zodiac

Postby busu4x4 » 23 Oct 2013 14:49

Razvan wrote:Si aici am dreptate,oricit mi-as dori sa te invadeze acasa pt 3-5 ore cei doi jnapani cu barci de aici. :lol:


:lol: :lol: :lol: RZV-ule, cred ca vrei sa te inscrii la "cursa pt Ban" :lol: :lol: :lol:
Live Free or Die Hard !!!!

AdrianZUZ
Posts: 303
Joined: 05 Oct 2010 09:37
Contact:

Re: Reparatii barci gonflabile gen zodiac

Postby AdrianZUZ » 23 Oct 2013 16:08

Razvan wrote:
Razvan wrote:.... Si aici am dreptate,oricit mi-as dori sa te invadeze acasa pt 3-5 ore cei doi jnapani cu barci de aici. :lol:


:lol: Nu este problem ... suntem incompatibili PVC+ adeziv hypalon = NU love!
:mrgreen: ATENTIE LA BICICLIST :mrgreen: !


Return to “Pescuit”

Who is online

Users browsing this forum: No registered users and 1 guest